![]() ![]() ![]() Two other Part Sets may be available for your system. Part Setting the System (using Part 2 or 3).The display will show, for example:- If the fault clears within 20 seconds then the exit tone will begin, if not, the fault tone will continue until a valid User code is entered. Tone will sound if any non exit routes are Zone 3 open. Īt the start of the setting procedure, a fault Exit Now!. The exit tone will now sound.Įxit the premises via an authorised exit route. * If enabled by the installation engineer. Two methods are available for Full Set.Īfter checking the premises are secure: Enter a valid User Code followed. The bottom line of the display will then be blanked off. Set or Unset Status will only be displayed for ten seconds when the system is Set or Unset. Display Status Blanking Depending on Control Panel installed, it may be a requirement that the Status (Set or Unset display) of the security system is not displayed.Throughout this manual, reference will be made to the Master User Code, the factory set default is 5678. Several user programmable options are available that will be covered later in this manual. Your installation company will have programmed your system to protect your premises to the highest possible standards. Introduction Welcome to the eurosec control panel.1 Display Status Blanking.2 IMPORTANT USER INFORMATION. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |